Declaration Of Conformity - Bosch GWS 6-115 PROFESSIONAL Instructions D'emploi

OBJ_BUCH-161-001.book Page 6 Tuesday, June 20, 2006 11:17 AM

Declaration of Conformity

We declare under our sole responsibility that this
product is in conformity with the following standards
or standardization documents: EN 50144 according
to the provisions of the directives 89/336/EEC,
98/37/EC.
Dr. Egbert Schneider Dr. Eckerhard Strötgen
Senior Vice President Head of Product
Engineering Certification
20.05.2006, Robert Bosch GmbH, Power Tools Division
D-70145 Leinfelden-Echterdingen
Assembly
Mounting the Protective Devices
Before any work on the machine itself, pull
the mains plug.
Protection Guard
For work with grinding or cutting discs, the
protection guard 7 must be mounted.
Place the protection guard 7 on the spindle collar.
Adjust the position of the protection guard 7 to the
requirements of the operation and lock the protection
guard 7 with the locking screw 6.
Adjust the protection guard 7 in such a man-
ner that sparking is prevented in the direc-
tion of the operator.
Auxiliary Handle
Operate your machine only with the auxiliary
handle 4.
Screw the auxiliary handle 4 on the right or left of the
machine head depending on the working method.
Vibration-dampening Auxiliary Handle
The vibration-dampening auxiliary handle reduces the
vibrations, making operation more comfortable and
secure.
Do not make any alterations to the auxiliary
handle.
Do not continue to use an auxiliary handle if it
is damaged.
1 619 P01 967 • 20.6.06
Hand Guard
For operations with the rubber sanding plate
14 or with the cup brush/wheel brush/flap
disc, always mount the hand guard 13.
The hand guard 13 is fastened with the auxiliary han-
dle 4.
Mounting the Grinding Tools
Before any work on the machine itself, pull
the mains plug.
Grinding and cutting discs become very hot
while working; do not touch until they have
cooled.
Clean the grinder spindle 5 and all parts to be
mounted.
For clamping and loosening the grinding tools, lock
the grinder spindle with the spindle lock button 1.
Actuate the spindle lock button only when
the grinder spindle is at a standstill. Other-
wise, the machine may become damaged.
Grinding/Cutting Disc
Pay attention to the dimensions of the grinding tools.
The mounting hole diameter must fit the mounting
flange without play. Do not use reducers or adapters.
When using diamond cutting discs, pay attention that
the direction-of-rotation arrow on the diamond cutting
disc and the direction of rotation of the machine (see
direction-of-rotation arrow on the machine head)
agree.
See graphics page for the mounting sequence.
To fasten the grinding/cutting disc, screw on the
clamping nut 10 and tighten with the two-pin spanner;
see Section "Quick-clamping Nut ".
After mounting the grinding tool and before
switching on, check that the grinding tool is
correctly mounted and that it can turn freely.
An O-ring (plastic part) is inserted
in the mounting flange 8 around the
centring collar. If the O-ring is
missing or is damaged, it must
in all cases be replaced (article
number 1 600 210 039) before
the mounting flange 8 is mounted.
Flap Disc
For operations with the rubber sanding plate
14 or with the cup brush/wheel brush/flap
disc, always mount the hand guard 13.
Place the special mounting flange (article number
2 605 703 028) and the flap disc on the grinder spin-
dle 5. Screw on the clamping nut 10 and tighten with
the two-pin spanner.
English–6