Würth EWS 7-115 BASIC Traduction Des Instructions De Service D'origine page 17

Dust from materials such as lead-containing
coatings, some wood types, minerals and
metal can be harmful to one's health and
cause allergic reactions, lead to respiratory
infections and/or cancer. Materials containing
asbestos may only be worked by specialists.
• As far as possible, use a dust extraction system suita-
ble for the material.
• Provide for good ventilation of the working place.
• It is recommended to wear a P2 filter-class respirator.
Observe the relevant regulations in your country for the
materials to be worked.
Prevent dust accumulation at the workplace.
Dust can easily ignite.
Secure the workpiece. A workpiece clamped with
clamping devices or in a vice is held more secure than by
hand.
After breakage of the grinding disc during operation or in
case of damage to the attachment fixtures on the protec-
tion guard/power tool, the machine must be sent immedi-
ately to a Würth-master Service.
Adjust protection guard in such a manner that
sparking toward the operator is prevented.
Do not touch grinding and cutting discs before
they have cooled down. The discs can become very
hot while working.
Actuate the spindle lock button only when the
grinder spindle is at a standstill. Otherwise, the
machine may become damaged.
After mounting the grinding tool and before
switching on, check that the grinding tool is
correctly mounted and that it can turn freely.
Make sure that the grinding tool does not
graze against the protection guard or other
parts.
When operating the machine with power from mobile
generators, loss of performance or untypical behavior can
occur upon switching on.
By applying too high application force, the
machine can be subject to overload. Overload
can lead to overheating and damage of the
power tool. After heavily straining the power
tool, continue to run it at no-load for several
minutes in order to cool it down.
Do not use the power tool with a cut-off stand.
Never use a cutting disc for roughing.
The quick-clamping nut may be used only for
grinding or cutting discs. Use only a flawless,
undamaged quick-clamping nut.
For operations with the rubber sanding plate
or with the cup brush/wheel brush/flap disc,
always mount the hand guard .
For cutting with bonded abrasives, always use
a protection guard for cutting.
Provide for sufficient dust extraction when cut-
ting stone.
Wear a dust respirator.
To save energy, only switch the power tool on
when using it.
Use only original Würth accessories.
Products sold in GB only: Your product is fitted with a
BS 1363/A approved electric plug with internal fuse (ASTA
approved to BS 1362).
If the plug is not suitable for your socket outlets, it should be
cut off and an appropriate plug fitted in its place by an author-
ised customer service agent. The replacement plug should
have the same fuse rating as the original plug.
The severed plug must be disposed of to avoid a possible
shock hazard and should never be inserted into a mains
socket elsewhere.
Products sold in AUS and NZ only: Use a residual cur-
rent device (RCD) with a rated residual current of 30 mA or
less.
Symbols
The following symbols are important for reading and under-
standing the operating instructions. Please take note of the
symbols and their meaning. The correct interpretation of the
symbols will help you to use the machine in a better and safer
manner.
Symbol Meaning
Article number
Read all safety warnings and all instruc-
tions
Before any work on the machine itself,
pull the mains plug from the socket outlet
Wear protective gloves
17