KitchenAid 720-0826E Instructions D'installation Et Guide D'utilisation Et D'entretien page 34
Comptoir pour gril d'extérieur autoportant
Masquer les pouces
Voir aussi pour 720-0826E:
Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Change the Side Burner Orifice
1.
Use a wrench to remove the side burner orifice brass
connector with flex line end to side burner tube.
2.
Use 6 mm socket wrench or 6 mm nut driver to remove the
orifice.
3.
Replace with the Natural gas orifice.
IMPORTANT: Check that the NG orifice is properly
installed inside of the valve.
4.
Reinstall the orifice support and supply pipe and tighten
the nut with a 24 mm wrench.
Change the Rotisserie Burner Orifice
1.
Use a screwdriver to remove the two screws from the
rotisserie burner heat shield. Remove the heat shield.
2.
Remove the four screws on the rotisserie burner rear
cover.
34
Publicité
Table des Matières
