Hofmann geodyna 8200 Manuel Opérateur page 88

12
88
4-10
Operation "MANUAL MODE"
Suggestion
Even if it is available, we suggest you do not select the
ALU mode manually for normal balancing procedures.
Changing the ALU in fact, if carried out before or after
a run, cancels the use of the Real Data obtained with
the Easy Alu procedure.
The machine proceeds by processing the Real Data
as if they were Nominal Data (entered manually).
Balancing will not be as precise.
No more ALU P modes will be available even if
selected.
5.12.2 "Easy Alu Toggle" function
Automatic correction of the proposed Alu
Depending on the gauge contact points on the rim,
the machine has interpreted a probable Alu mode
required by the user. Every time the Alu presented
by the machine does not correspond exactly to the
one required, it can be corrected using the "Easy Alu
Toggle" function.
 Press the "Easy Alu Toggle" key (12, Fig. 4-10) if
you want the alternative Alu mode to that suggested
for the rim.
Note: The Alu can be changed only before the
measuring run.