Assembly; Attach The Motor Cover; Attach The Spindle Tilt Wheel; Attach Storage Hooks - Delta 31-484 Manuel D'utilisation

ATTACH THE MOTOR COVER

See Figure 1
1. Slide the hinge pins (A) in the motor cover into the
hinge holes located on the motor housing.
2. Carefully press in the left side of the motor cover
until the knob (B) engages in the opening.
3. Tighten the lock knob on the motor cover.

ATTACH THE SPINDLE TILT WHEEL

See Figure 2
1. Place the spindle tilt wheel (A) over the threaded
shank by aligning the slot in the spindle tilt wheel
with the pin in the shank.
2. Attach the knurled spindle tilt retaining knob (B) by
screwing it onto the shank.

ATTACH STORAGE HOOKS

See Figure 3
To protect sanding spindle assemblies and the table
inserts, it is recommended that you use the on-board
storage to keep them safely out of the way and within
easy reach.
The six table inserts and two spindle wrenches can be
stored on the left side of the machine. Attach the two
storage hooks (A) to the machine using two M5 X 15
Phillips round head screws.
The ten spindle assemblies can be stored in the fitted
compartments on either side of the machine.

ASSEMBLY

8
FIGURE 1
FIGURE 2
FIGURE 3