Connecting A Network Camera; Connecting Other Devices; Connecting Remote Client - Sony IPELA NSR Série Manuel D'installation

Note
The default IP address for LAN port 1 is follows;
• LAN connector 1 : 192.168.0.1
• LAN connector 2 : 192.168.1.1 (only the NSR-100/
50)
• LAN connector 3 : 192.168.2.1 (only the NSR-100/
50)
If you want to change the default IP address, refer to the
"User's Guide" (PDF) on the supplied "NSR Series
Manual, Tool & Source Codes CD".

Connecting a Network Camera

Use a network cable to connect LAN connector 1 to a
network switch, and then connect the desired network
camera to the network switch with another network
cable.
Network switch
Network Camera

Connecting Other Devices

Using a CompactFlash Card (Only the
NSR-100/50)
Insert your CompactFlash card in the direction
illustrated. Make sure that you insert your card with the
label side facing up and in the direction of the arrow.
POWER LAN 1 2 3 HDD 1 2 3 4 STATUS 1 2 3 4
When ejecting a CompactFlash card, press the eject
button on the left of the card slot.
Connecting an Uninterruptible Power
Supply
1
Connect the uninterruptible power source to the
power outlet.
2
Connect the NSR to the UPS with the supplied
power cord .
ERROR REC
3
Connect the NSR to the UPS with the dedicated
serial cable to the serial connector on the rear of the
NSR.

Connecting Remote Client

If a remote client is required, the RealShot Manager
(hereafter RSM) Controller software can be used.
RSM Controller runs on Windows computers. For
details on system requirements, refer to the release notes
accompanying the RSM Controller install archive.
1
Use a network cable to connect LAN connector to
a network switch.
When using the NSR-100/50, connect to LAN
connector 2 on the unit.
2
Connect the network cable to a computer when
RSM Controller software is installed.
Network switch
Windows PC
Notes
• For details on installation and other topics related to
the RSM Controller software, refer to the supplied
NSR Series Manual, Tool & Source Codes CD.
• The connection port for the RSM server function on
the NSR unit is "8081".
• When using the NSR-100/50, use LAN connector 2 at
the rear of the NSR even if connecting it to the user
area of a network.
(For the NSR-100/50)
RSM Controller
software
15
Installation