Sony IPELA NSR Série Manuel D'installation page 13

2
Install the rails on the rack.
(1) Adjust the length of the rails to match the length
of your rack.
(2) Use the supplied truss screws and washers to
secure both ends of the rails to the rack.
Mounting the NSR on the Rack
Insert the NSR into the rack, and then secure it.
Caution
At least two people are needed in order to handle the unit
to prevent personal injury.
1
Pull the sliding rails from the rail assemblies.
2
3
Truss
screws
Washers
Lift the NSR, fit the inner rails into the slide rail
grooves (white), and then slide the assembly until it
stops.
Inner rail
As you pull the green tab inward to release the lock,
slide the NSR as far as it can go.
Green tab
13
Installation