Timer Setting; Temperature Setting; Overheat Safety Device - Ayce DF-150A7-7 Mode D'emploi

device is working at the low power setting (
4. Press the "Power" button to choose the below functions:
low power " " high power " "
Power setting:
DF-150A7-7 DF-200A7-9
0 OFF OFF
750 W 1000 W
1500 W 2000 W
5. Press the "MODE" button to choose timer "
function:

5.1 Timer setting:

Press the button "MODE", when the timer symbol "
be set between 0-24 hours with the help of the "+" and "-" buttons.
By setting the timer in stand by mode, the appliance can automatically
switch on at the set time.
By setting the timer while the appliance is in operation, the appliance will
automatically shut off once the set time is reached.

5.2 Temperature setting:

Press the button "MODE", the temperature symbol "
temperature between 15°C and 35°C with the help of the "+" and "-" buttons.
6. Press the main supply switch "5" to position "0" to turn off the appliance. Unplug
the appliance then after.
The same function is available by remote control. (Fig. 6)
• Make sure the battery (2 X AAA not included) are installed properly in the
remote control.
• The eff ective range of the remote control is up to 4 meters.
).
DF-250A-11 DF-300A7-13
OFF OFF
1250 W 1500 W
2000 W 3000 W
" and temperature setting " "
" is blinking, the timer can
" is blinking, set the
BATTERY
The remote control requires 2 x AAA battery. We recommend the use of alkaline type
battery for longer use.
Note: Please follow battery disposal instruction on the battery packaging, or contact
your local councils for safe disposal of batteries.
TIP-OFF SAFETY DEVICE
This appliance is provided with a safety device which will switch off the heater in
case of accidental tipping. To reset, disconnect the plug from the power outlet for a
few minutes, remove the cause of tipping off , then plug the appliance in again. If it
still cannot be reset, ask a qualifi ed technician to check and repair the appliance.

OVERHEAT SAFETY DEVICE

Your heater is fi tted with a safety device to switch off the heater in the event of
overheating. If the safety device is in operation, please turn the heater off , unplug the
appliance and let it completely cool, inspect for blockage of air inlet or outlet,
attempting to restart the heater then after. If the heater fails to operate or the safety
device switches the heater off again, return heater to your nearest service center for
examination or repair.
38 | 39
GB