Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
knob or "DOWN-"on remote control to decrease the
desired temperature.
When the air temperature reaches 2°C above the set
2.
temperature, the heater will cut o automatically.
When the air temperature drop 2°C below the set
3.
temperature, the heater will come back on automatically.
The selected temperature range is 5°C - 40°C.
4.
Timer setting
1.
Timer ON setting: Press the "
remote control one time, the "
flicker, and you can press the "
remote control, "
" knob or "DOWN-"on remote
control to increase or decrease the hours. The timer
function allows you to set the length of operation from
30minutes to 24 hours. Ready the setting 3 seconds later,
the "ON" will remains lit.
2.
Timer OFF setting: Press the "
remote control twice time, the "
to flicker, and you can press the "
remote control, "
" knob or "DOWN-"on remote
control to increase or decrease the hours. The timer
function allows you to set the length of operation from
30minutes to 24 hours. Ready the setting 3 seconds later,
the "OFF" will remains lit.After reach the setting times of
OFF, the heater will stop working and flicker the "End",
and hear D-D-D three sounds. Press the "SET:" button,
the heater will start to rework.
Remark: On FROST mode, it can't set the timer OFF or ON.
Note: It is normal for heater to cycle ON and OFF as it
maintains to set temperature and working mode.
" or "TIMER" knob on
" and "ON" will begin to
" knob or "UP+"on
" or "TIMER" knob on
" and "OFF" will begin
" knob or "UP+"on
MAINTENANCE
WARNING: ALWAYS UNPLUG THE CORD BEFORE MOVING
OR SERVICING
CLEANING: IMPORTANT! DO NOT IMMERSE HEATER IN
WATER! DO NOT TRY TO DISASSEMBLY THE HEATER. DO
NOT REMOVE GRILL.
CAUTION: Do not use gasoline, benzene, thinner, harsh
cleaners, etc. as they will damage the Heater. NEVER use
ALCOHOL OR SOLVENTS.
STORAGE: Store the heater with these instructions in the
original carton in a cool, dry place
The Main Power Switch and the On/O
switch should not be used as the sole
means of disconnecting power. Always
WARNING :
unplug the power cord before servicing or
moving the unit.
To avoid danger of electric shock, unplug
from outlet when not in use and before
cleaning. If the supply cord is damaged, it
WARNING :
must be replaced by the manufactory or
its service agent or a similarity qualified
person in order to avoid a hazard.
48 49
38 39
Publicité
Table des Matières
