Ayce SM-20E Mode D'emploi page 24

ASSEMBLY
Unpack the heater and the accessories.
1. Fix the caster into the feet mounting hole(Figure 2).
2. Fix the 2 feet into the bottom groove of the
radiator,double check the R&L distinguish(Figure 3).
3. As shown (Figure 4)with 2
screws of ST4*14 is fixed
into the correspond hole.
OPERATION
The heater may be operated by the manual controls located
on the heater (as shown in Figure 1) or by your remote
control.
(FIGURE 5)
1. Place the heater on a firm, level surface.
2. Plug the cord set into a fit electrical outlet. Press the main
power switch at the bottom of right housing (Power
switch location see Figure 1). When heater is power on,
the LCD display will show the room temperature.
3. Turn on the heater by pressing the power button upper
control panel, and it is LOW mode, the power is 750 W.
Press the "SET" knob to MIDD mode, the power goes up
to 1250 W.
Press twice times the "SET" knob to HIGH mode, the
power goes up to 2000W.
Press three times the "SET" knob to the AUTO mode. The
heater works at di erent power which accord to the air
temperature.
a) When the air temperature is lower than 15°C, the
heater will work at HIGH mode automatically.
b) When the air temperature is at 16°C -20°C, the heater
will work at MIDD mode automatically.
c) When the air temperature is more than 21°C below 23°C,
the heater will work at LOW mode automatically.When
the air temperature reaches to 25°C, the heater will
cut o automatically. When the air temperature drop
to 23°C, the heater will come back on LOW mode
automatically.
Press four times the "SET" knob to the FROST mode; the
working position is 7°C for air temperature.
4. To turn the Heater OFF, by pressing the Power button
again and turn o power switch. (See Figure 1)
Setting the temperature (figure 2) :
1. To set the temperature, when the LOW or MIDD or HIGH
mode, Press the " " knob or "UP+"on remote control
to increase the desired temperature and press "
46 47 36 37
"