Fireplace Xtrordinair 6015 HO GSR2 Manuel Du Propriétaire page 56

56 Installation
6. Follow the directions below to replace the orifice.
a
Slide the air shutters to provide access to the orifices.
9/16" Wrench
d
Screw the LP orifice until orifice
protrudes 15/16" (23.8mm)
indicating full insertion (use
wrench to secure manifold when
re-attaching orifice).
7. Install the LP pilot orifice following the instructions below.
(a) Use a 7/16" open-end wrench to remove the pilot hood.
(b) Remove and discard the Natural Gas (NG) orifice. Place the LP orifice in the pilot assembly then replace
the pilot hood, tightening the pilot hood until it is snug (do not over-tighten).
© Travis Industries
(pour des installateurs qualifiés seulement)
b
1/2" Wrench
Rear
Orifice
15/16"
23.8mm
6/1/2020 – 1366-FR
Use a 9/16" wrench to secure the
manifold while removing the orifice
with a 1/2" wrench.
c
Apply thread sealant to the LP orifice prior
to installation. Use the chart below to
identify the correct orifices.
Look here for the orifice identification
NG
Left Side 2.5mm
Right Side 2.5mm
LP
#53
#53
6015 HO GSR2 French