Technical Data; Installation Of The Mains Plug - SKF TIH 200m Mode D'emploi

2.2 Technical Data

TIH 220m
Voltage (±10%):
TIH 220m/MV
TIH 220m/LV
Recommended line protection:
TIH 220m/MV
TIH 220m/LV
Power consumption (maximum)
Temperature control
Probe type
Probe maximum temperature
Time mode
Power range
Demagnetisation
Overall dimensions (w x d x h)
Area between supports (width x height)
Coil diameter
Weight (with yokes)
Workpiece maximum weight
Maximum heating temperature
m *
20
Standard yoke dimensions:
70 x 70 x 430 mm (2.8 x 2.8 x 16.9 in)
40 x 40 x 430 mm (1.5 x 1.5 x 16.9 in)
* m represents the weight (kg) of the heaviest SRB 231 bearing that can be heated from
20
20 to 110 °C (68 to 230 °F) in 20 minutes.

3. Installation of the mains plug

A qualified electrician must install a suitable mains plug. The correct supply voltage is
shown in section 2.2.
The wires should be connected as follows:
8
400 - 460V / 50 - 60Hz
200 - 240V / 50 - 60Hz
minimum requirement 25 A
minimum requirement 50 A
10,0 - 11,5 kVA for 400 - 460 V
0 - 250 °C (32 - 482 °F); in steps of 1°
thermocouple, K type
250 °C (482 °F)
0 - 60 minutes; in steps of 0.1 minute
100% - 50%
automatic; residual magnetism <2A/cm
750 x 290 x 440 mm (29.5 x 11.4 x 17.3 in)
250 x 255 mm (9.8 x 10.0 in)
140 mm (5.5 in)
For minimum bearing bore diameter of
150 mm (5.9 in)
86 kg (189 lbs)
Bearing: 300 kg (661 lbs)
Solid component: 150 kg (330 lbs)
approx. 250 °C (482 °F)
Depending on bearing or workpiece weight.
For higher temperatures, please contact SKF.
220 kg (bearing 23172)
For minimum bearing bore diameter of:
100 mm (3.9 in)
60 mm (2.3 in)
SKF TIH 220m