Operation; Function Of Displays; Function Of Buttons; Temp Mode - SKF TIH 200m Mode D'emploi

5. Operation

5.1 Function of displays

A The remote control display shows the selected time or temperature for heating.
B The power LED's show the selected power setting.
Display Indication
t time in minutes
°C temperature in degrees Celcius
°F temperature in degrees Fahrenheit

5.2 Function of buttons

Button
POWER
MODE
UP (+)
DOWN (-)
START / STOP

5.3 Temp Mode

• If the remote control display shows 't' , press MODE to select TEMP MODE.
The remote control display shows °C or °F in TEMP MODE.
• The selected temperature is shown on the remote control display. The default
temperature for bearings is 110 °C (230 °F). If a different temperature is desired,
press UP or DOWN to adjust the temperature in steps of 1°.
• It may be desirable to heat bearings to temperatures above 110 °C (230 °F) for
increased mounting time. Consult the SKF bearing specifications to determine the
maximum permitted temperature. Always ensure the bearing does not lock due to
an excessive expansion of the inner ring compared to outer ring. See section 5.8.
• If needed, press POWER to select the power level. Use the guidelines in section 5.8
to determine the correct power setting.
• Make sure the temperature probe is mounted on the bearing inner ring.
• Press START / STOP to start the heater. The remote control display shows the
current temperature of the workpiece.
• During heating the selected temperature can be displayed for 1 second by pressing MODE.
10
Function
Press to adjust the power. The selected power is indicated with an LED
Press to switch between TIME MODE and TEMP MODE
Press to increase the value shown on the remote control display
Press to decrease the value shown on the remote control display
Press to start or stop the heater. The LED on the START / STOP
button is lit when the heater is heating and flashes during
temperature measurement
A
B
50% 100%
POWER
SKF TIH 220m
START
STOP
TIH RC