Sony MV-700HR Mode D'emploi page 11

1
Remove the headrest and attach the
installation kit to the rods.
You can adjust the lateral position of the
monitor by sliding the installation kit from
side to side before tightening the screw.
Front
2
Attach the installation cradle to the
installation kit and tighten the screw on
the bottom using things like a coin.
Installation
cradle
C
Adjust the angle of your monitor with the
knob C.
Note
The backside of the installation cradle should be
pressed against the headrest for the stable
installation.
Removing the player from the
installation cradle
Remove the player while pressing the button
on the installation cradle.
Push to
release
Using the rechargeable battery
pack
Attach the rechargeable battery pack as
illustrated below.
Slide up the rechargeable battery pack until
you hear the click sound.
Removing the rechargeable battery
Installation kit
pack from the player
Push the release button on the rechargeable
battery pack and slide it off.
Charging the rechargeable battery
pack
Charge the rechargeable battery pack using AC
power adaptor and AC power cord. You can
charge the rechargeable battery pack while it is
Installation kit
attached to the unit.
AC power adaptor
(supplied)
To a wall
AC power cord (supplied)
outlet
Rechargeable battery
pack MV-100BAT
(supplied)
Push to release
11