Remote Control - Pioneer HTP-SB300 Mode D'emploi

03 Controls and displays

Remote control

SYSTEM SYSTEM
1
2
HDMI1
5
OPTICAL
STANDARD
7
AUTO/
DIRECT
LISTENING MODE
9
10
12
14
 SYSTEM
1
Switches the system between standby and on.
2
Switches the remote to control the system.
Also use to adjust the Audio parameters
(page 24).
18
En
INPUT SOURCE
INPUT TV CONTROL
HDMI2
CH
COAXIAL INPUT
TV CODE
ADV SURR
STEREO/
VOL
DIMMER
A.L.C.
BD MENU
ENTER
MUTE
DISPLAY
CH
CH
ENTER
SURROUND SYSTEM
3 INPUT SELECT
3
Use to select the input source.
4
SOURCE
4
Press to turn on/off other components
connected to the system (see page 30 for more
on this).
6
5 INPUT SELECT buttons
Use to select the input source. Switch the
remote control to operate any other components
allocated to the selected buttons (see
Controlling the rest of your system on page 27).
8
6 TV CONTROL buttons
These buttons are dedicated to control the TV
assigned to the
only have one TV to hook up to this system
assign it to the
11
for more on this).

Use to turn on/off the power of the TV.
INPUT
13
Use to select the TV input signal.
Press to select control of TV. Also use to
15
input a preset code allocated to the TV
CONTROL button.
CH +/–
Use to select channels.
16
VOL +/–
Use to adjust the volume on your TV.
7 Listening mode buttons
AUTO/DIRECT
Switches between Auto surround mode
(Auto playback on page 21) and Stream
Direct playback. Stream Direct playback
bypasses the tone controls for the most
accurate reproduction of a source
(page 23).
button. Thus if you
button (see page 29