Sharp KC-D60EU Manuel page 20

TROUBLESHOOTING
When the Roller / Float / Tray partition was
removed.
FLOAT
1. Insert the float
under this tab.
3. Insert the tab on the
other side of the float
into the hole.
AUTO RESTART
After a power failure, automatically resume
the operation when the power recovers.
ON
(with the unit OFF)
(simultaneously for more than
3 sec.)
KC-D60-50-40EU_UA-HD60-50-40E_west_2025.indb 18 KC-D60-50-40EU_UA-HD60-50-40E_west_2025.indb 18
SYMPTOM
2. Inner the tab
of float into
the hole.
Tab
Cross-Section view
If the ,
for 10 seconds, the setting is
complete.
REMEDY (not a malfunction)
• Install the Roller / Float / Tray partition in order
below.
Tray partition
Humidifying tray
ROLLER
Fix the roller in the tray from side way.
Float
Float
Auto Restart can be set.
• Even when the plug is unplugged or the breaker
is thrown during the operation, the operation re-
sumes at the previous operation mode and set-
tings if the power recovers.
CANCELLATION
(with the unit OFF)
(simultaneously for more than
3 sec.)
, lamp lights up
EN-18
Click
12.06.2025 12:07:46 12.06.2025 12:07:46