Horizon Fitness CE4.3 Manuel Du Propriétaire page 13

ASSEMBLY STEP 4
DO NOT REMOVE FROM BARS:
SNAP RING
FLAT WASHER
ARC WASHER
WATER BOTTLE HOLDER
PRE-INSTALLED SCREWS
CONSOLE MAST
UPPER HANDLEBAR
NOTCH
PRE-INSTALLED SET SCREWS
TAB
PRE-INSTALLED
BOLT & WASHER
LOWER HANDLEBAR
NOTE: The hardware for this step is pre-installed.
Remove PRE-INSTALLED BOLT &
A
WASHERS from CONSOLE MAST.
Slide LOWER HANDLEBARS onto
B
CONSOLE MAST and attach by re-inserting
PRE-INSTALLED BOLT & WASHERS.
Slide UPPER HANDLEBARS onto LOWER
C
HANDLEBARS and align NOTCH with TAB
making sure handlebars are joined together
completely. Secure UPPER HANDLEBARS
to LOWER HANDLEBARS using PRE-
INSTALLED SET SCREWS.
Repeat on other side.
D
Attach WATER BOTTLE HOLDER to
E
CONSOLE MAST using PRE-INSTALLED
SCREWS.
NOTE: After handlebars are assembled they will
rotate freely – be cautious. Until the machine is
fully assembled, do not grab the handlebars for
support.
13