Installing The Receiver - Alpine EZi-DAB-GO Manuel D'utilisation

Installing the receiver

We recommend installing EZi-DAB-GO's receiver on your vehicle's windscreen as described below (see page 5 for more information).
8
1. If you decided to fit the magnetic grounding tail, gently pull down the
front of the roof liner so that there is enough room to push the detachable
magnetic grounding tail through the gap.
Note: Ensure that the magnet on the end of the magnetic grounding
tail makes contact with the roof above your vehicle's headliner or the
vehicle's metal bodywork surface.
2. Use the supplied cleaning wipe to clean the area of the windscreen
that you want to install the receiver and film antenna on and wait for the
surface to dry. Important: Ensure the surface is completely clean and dry
before adhesion.
Note: The receiver and antenna should be installed at least 40mm from
your vehicle's metal bodywork.
3. Remove the backing from the receiver (A) and attach to your windscreen.
Note: Make sure that you install EZi-DAB-GO in a safe position where
the primary viewing area is not obstructed (see page 5).
4. Gently unpeel the backing of the film antenna (B) and attach to your
B
windscreen, taking care not to bend it. Apply gentle pressure until the film
antenna is held firmly in position.
A
Note: Take care not to unclip the film antenna from the receiver when
attaching to your windscreen.