Resetting EZi-DAB-GO to factory settings
Resetting EZi-DAB-GO removes any stored presets, clears the station list and resets all options to defaults.
1.
Press the
button.
2.
Turn and press the Select dial to choose 'SETTINGS' > 'RESET'.
3.
To reset EZi-DAB-GO, turn and press the Select dial to choose 'YES' or choose 'NO' if you don't want to reset EZi-DAB-GO.
Wait for EZi-DAB-GO to reset.
Note: If you can't access the 'RESET' menu, you can reset EZi-DAB-GO using the Reset button on EZi-DAB-GO's receiver. See the
'Troubleshooting' section of this user guide.
Appendix
Troubleshooting
I can't reset EZi-DAB-GO to factory settings from my wireless controller
If you can't access the 'RESET' menu on your wireless controller, you can reset EZi-DAB-GO using the Reset button on EZi-DAB-GO's receiver.
Note: You will need to use a paperclip or pen to reset EZi-DAB-GO to factory settings.
To reset EZi-DAB-GO to factory settings:
1.
Remove and re-insert the EZi-DAB-GO power adapter into the 12V accessory socket.
2.
Within 5 seconds, while the Status LED on EZi-DAB-GO's receiver is lit solidly, use a paperclip or pen to press the Reset button.
The Status LED will flash rapidly three times to indicate that the factory reset has started.
My wireless controller displays a 'Antenna connecting' message
Check the power supply to the receiver is properly inserted into your vehicle's power socket.
Check that EZi-DAB-GO is not in USB upgrade mode.
Power cycle your receiver by removing and re-inserting the USB EZi-DAB-GO power adapter.
The Status LED on EZi-DAB-GO's receiver is constantly illuminated
If the Status LED on EZi-DAB-GO's receiver is constantly illuminated, it means that EZi-DAB-GO is expecting a software update via the
USB connection. If this is unintentional, you can exit USB update mode by removing the power or by holding down the Reset button
for 10 seconds.
EN
23