Mounting Steps - Lenze 9400 Instructions De Montage

5.3

Mounting steps

Proceed as follows for the installation:
1. Prepare M5 threaded holes on the mounting plate according to the mounting grid.
– Always use all mounting points specified.
2. Screw the device onto the mounting plate. Do not yet tighten the screws.
– Use M5 screw and washer assemblies or M5 hexagon socket screws with washers.
3. Repeat step 2 for installation backplanes, which can be mounted directly adjacent to
one another.
4. Align all devices and installation backplanes.
5. If busbars are used: connect the busbars.
6. Tightly screw all devices and installation backplanes onto the mounting plate.
– Tightening torque: 3.4 Nm (30 lb−in).
EDK94PNE245 DE/EN/FR/ES/IT 4.0
Mounting the device
l
Mounting steps
5
57