Automatic Shutoff; Safety System; Cleaning And Maintenance - WMF LONO Série Mode D'emploi

Start-up
The kettle is made from stainless steel and original Schott DURAN® glass. It is heat resistant, stable,
neutral tasting and easy to clean.
Thoroughly clean the inside of the pot prior to the first use. To do so, open the lid by pressing the
button on the handle.
A strainer insert in the pour spout ensures that larger limescale particles are kept back when pouring.
The unnecessary length of the connecting cable can be wound at the bottom of the base part.
Connect the mains plug to an earthed socket.
Fill with the desired amount of water up to the Max line. Close the lid. Only in this way does the
automatic boil stop work reliably.
Place the pot on the base in any position. Now you can press down the power switch below the
handle. The control lamp in the power switch shows that the device is heating.
The power switch only engages if the pot is on the base.
Do not use the water from the first boiling process for food preparation.

Automatic shutoff

The automatic boil stop switches off the device shortly after the water is boiled. The shutoff time is
extended if the pot is only filled with a little water.
If only warm water is desired, the heating process can always be stopped by pressing the power switch.
The shutdown takes place automatically if the pot is lifted from the base.
For functional reasons, some condensation may run out of the outlet openings at the bottom of the
handle to the edge of the base. This happens for technical reasons and does not impair the safety of
the device.

Safety system

A thermostat protects the kettle from overheating due to accidental operation without water by
switching off the device.
It is essential to allow the pot to cool down before filling with water.
Should the first thermostat malfunction due to improper use, an additional temperature limiter
ensures reliable protection.
10

Cleaning and maintenance

Remove the mains plug and allow the device to cool down. Do not immerse the device in water, but
rather clean them with a damp cloth with a little washing-up fluid and then dry off.
Do not use any sharp and abrasive cleaning agents.
You can remove the lid for easy cleaning. To remove the lid, press on the button on the handle and
pull the lid upwards into position 2 until the lid unlocks. Then pull the lid upwards to remove it.
When you re-fit the lid make sure that you first place it in position 1 and then lock it into place in
position 2.
The strainer insert in the pour spout can be removed for cleaning when the lid is open. To do so, press
its upper clip upward. When inserting, place the strainer in the middle of the base and then snap it
forward into place.
11