Manual 2 Or 3 Stages Heating - Panasonic NE-1037 Mode D'emploi

Manual 2 or 3 Stages Heating:

This feature allows you to set to begin heating at one power level then shift automatically to a different power
level after the designated length of heating time.
Example: To heat for 2 minutes at 340 W for 2 stage heating
PAD
3.
4.
5.
6.
Beep tone will sound.
(See page 21)
NOTE: • For 3 stages heating, repeat steps 3 and 4 above before pressing Start Pad.
SPECIAL NOTE: For both single and 2 or 3 stages heating.
• The maximum cooking time for "
NE-1037_EYG.indb 14
How to Operate
• Follow steps 1 and 2 on page 13.
• Press the Power Level Pad 3 times. Indicator will
change each time the pad is pressed. "
displayed. The stage "2" is blinking.
• Press the Memory Pads 2, 0 and 0.
• Press the Start Pad.
The total time for both stages will be displayed.
The stage "1" and the power level "
The oven lamp will be turned on. Heating will start
and the time will count down.
• When oven shifts to the next stage, a single beep
tone will sound. The stage "2" and the power level
" " blink.
• All heating will stop.
When opening the door, the display will stop
blinking.
" (1000 W) is up to 30 minutes.
- 14 -
INSTRUCTION
" is now
" blink.
2020/11/25 10:37:18