Makita BO5041 Manuel D'instruction page 6

1
003326
OPERATION
CAUTION:
Always use the front grip and firmly hold the tool by
•
front grip and switch handle during operations.
Sanding operation
011083
CAUTION:
Never run the tool without the abrasive disc. You
•
may seriously damage the pad.
Never force the tool. Excessive pressure may
•
decrease the sanding efficiency, damage the
abrasive disc or shorten tool life.
Using the tool with the pad edge contacting the
•
workpiece may damage the pad.
Hold the tool firmly. Turn the tool on and wait until it
attains full speed. Then gently place the tool on the
workpiece surface. Keep the pad flush with the
workpiece and apply slight pressure on the tool.
CAUTION:
The sanding pad rotates clockwise during the loaded
operation, but it may rotate counterclockwise during the
no-load operation.
Polishing operation
CAUTION:
Use only a Makita genuine sponge pad, felt pad or
•
wool pad (optional accessories).
Always operate the tool at low speed to prevent
•
work surfaces from heating abnormally.
Never force the tool. Excessive pressure may
•
decrease the polishing efficiency and cause motor
overload, resulting in tool malfunction.
1. Dust nozzle
6
1. Applying wax
1
011086
Use an optional sponge pad. Apply wax to the
sponge pad or work surface. Run the tool at low
speed to smooth out wax.
NOTE:
First, wax a not conspicuous portion of the work
•
surface to make sure that the tool will not scratch
the surface or result in uneven waxing.
Always run the tool at low speed. Running it at high
•
speed may cause the wax to spatter.
2. Removing wax
1
011085
Use an optional felt pad. Run the tool at low speed
to remove wax.
3. Polishing
1
011084
Use an optional wool pad. Run the tool at low
speed and apply the wool pad gently to the work
surface.
1. Sponge pad
1. Felt pad
1. Wool bonnet