Operation; Pressure Test; Setting The Working Pressure - GF 582 Manuel D'utilisation

Operation

10 Operation

10.1 Pressure test

 Ensure that the test pressure does not exceed 1.1 times the max. set back pressure.

10.2 Setting the working pressure

 Remove the cap from the bonnet assembly (top part), see Fig. 2. To do so, position the
screw driver in the notch of the cap.
Fig. 2
 Loosen the locking nut, see Fig. 3
Fig. 3
 In order to increase the setpoint value: Tense the spring. To do so, turn the spindle
clockwise, see Fig. 4
Fig. 4
36
1 ½
Umdrehungen
Instruction manual