Schumacher Electric IP-1825FL Guide D'utilisation page 8

Masquer les pouces Voir aussi pour IP-1825FL:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

5.
After the engine starts, disconnect the black clip (-) and then the red clip (+) in that
order.
6.
Recharge the Instant Power™ as soon as possible after use.
RISK OF ExPLOSION.
To prevent sparking, NEVER allow the clips to touch together or to contact the
same piece of metal. Never attempt to jump start a frozen battery.
4.2
Powering a 12V DC Device:
The Instant Power™ is a power source for all 12V DC accessories that are equipped
with a 12V accessory plug. Use it for power outages and fishing or camping trips.
Estimated usage time is listed in the chart below.
Make sure the device to be powered is OFF before inserting the 12V DC accessory plug
into the 12V DC accessory outlet.
1.
Open the protective cover of the DC power outlet on the front of the Instant Power™.
2.
Plug the 12V DC device into the DC power outlet, and turn the 12V DC device on (if
required).
3.
If the 12V DC device draws more than 20A or has a short circuit, the external circuit
breaker of the Instant Power™ will trip and disconnect the power to the device. If this
occurs, disconnect the 12V DC device in question and press the reset button located
on the back of the Instant Power™ to reset the circuit breaker.
The DC power outlet is wired directly to the internal battery. Extended operation of a
12V DC device may result in excessive battery drain. Recharge immediately after
unplugging the 12V DC device.
Appliance Type
Cell Phone
Fluorescent Light
Radios, Fan
Depth Finder
Camcorder, VCR
Electrical Tool
Electrical Cooler
Car Vacuum, Air Compressor
NOTE: Estimated run-times. Actual time may vary. Times are based on the internal
battery being fully charged
4.3
Using the Built-In Light
1.
Position the Instant Power™ on a flat, stable surface near the intended work area.
2.
Ensure the battery clips are securely clipped on the storage holders.
3.
Press the light switch button once.
4.
The Instant Power™ light will turn on and illuminate your work area.
5.
Press the light switch button again when the work is completed.
6.
Charge the Instant Power™ as soon as possible after using the built-in light.
Estimated Wattage
4 watts
4 watts
9 watts
9 watts
15 watts
24 watts
48 watts
80 watts
4
Estimated Usage Time
54 hours
54 hours
24 hours
24 hours
14.4 hours
9 hours
4.5 hours
2.7 hours

Publicité

Table des Matières
loading

Table des Matières