Operation; Connection And Control Devices - ESAB Migmaster 280 Pro Manuel D'instructions

GB
6

OPERATION

General safety regulations for the handling of the equipment can be found on
page 4. Read through before you start using the equipment!
WARNING!
Rotating parts can cause injury, take great care.
WARNING - - TIPPING RISK!
There is a risk of tipping while transportation and operation, if the welding machine leans
o
more than 10 . In that case appropriate securing has to be provided !
6.1

Connection and control devices

1 Mains supply switch
2 Orange indicating lamp, overheating
2a White indicating lamp "ON"
3 Welding voltage switch (fine)
3a Welding voltage switch (coarse)
4 EURO -- connector for welding gun
5 Connector [+] for "electrode" or return cable
(welding polarity change--over)
5a Connector [--], high inductance, for welding gun
or return cable (welding polarity change--over)
MMP280e
5b Connector [--], low inductance, for welding gun or
return cable (welding polarity change--over)
6 Knob for spot welding -- ON/OFF and time setting
7 Knob for wire speed setting
8 Digital instrument -- V/A
9 Connector for "spool--on gun" (control wire)
10 Knob for burn--back time setting
(located in wire feeder compartment)
11 "Electrode" cable with plug, connected to the weld-
ing gun connector (welding polarity change--over)
12 Creep start switch
(located in wire feeder compartment)
- - 9 - -