Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
REAR PANEL FEATURES
11
12
10
1.
PHONO INPUTS (RCA) – Connect phono-level devices, such as turntables, to these inputs.
2.
GROUNDING TERMINAL – If you are using phono-level turntables with a grounding wire, connect the grounding wire to
these terminals. If you experience a low "hum" or "buzz", this could mean that your turntables are not grounded.
Note: Some turntables have a grounding wire built into the RCA connection and, therefore, nothing needs to be
connected to the grounding terminal.
3.
LINE INPUTS (RCA) – Connect line-level devices, such as CD players, samplers or audio interfaces, to these inputs.
4.
MIC INPUTS – Connect ¼" microphones to these inputs.
5.
FADER START – If you would like to use the mixer's fader-start to automatically start and cue music from external
devices via the crossfader, connect these outputs to your fader-start compatible device. You can use standard 1/8"
stereo cables to make these connections.
6.
ZONE OUTPUT (RCA) – Connect this output to an external monitoring device, such as a PA system, powered monitors,
or a home stereo. The level of this output with the ZONE knob on the top panel.
7.
RECORD OUTPUT (RCA) – Use standard RCA cables to connect this output to a recording device, such as a CD
recorder or tape deck. The level of this output is based upon pre-master levels.
8.
MASTER OUTPUT (RCA) – Use standard RCA cables to connect this output to a speaker or amplifier system. The
level of this output is controlled by the MASTER knob on the top panel.
9.
MASTER OUTPUT (BALANCED) – Use XLR cables to connect this Master output to a speaker or amplifier system.
The level of this output is controlled by the Master knob on the top panel.
10.
POWER IN – Use the included power cable to connect the mixer to a power outlet. While the power is switched off, plug
the power supply into the mixer first, then plug the power supply into a power outlet.
11.
VOLTAGE SELECTOR – This 2-position switch sets the AC input voltage for the speaker. U.S. users should set this
switch to "100-120V" whereas U.K. and most European users will need to set this to "220-240V".
12.
POWER SWITCH – Turns the mixer on and off. Turn on the mixer after all input devices have been connected and
before you turn on amplifiers. Turn off amplifiers before you turn off the mixer.
5
4
8
7
6
3
9
5
2
4
3
3
3
3
3
1
3
3
2
2
1
3
3
1
Publicité
Table des Matières
