Operation Conditions - Panasonic CS-TZ9SKEW Comment Utiliser L'appareil

To select fan speed
FAN SPEED
(
Remote control display
AUTO
FAN
• For AUTO, the indoor fan speed is automatically
adjusted according to the operation mode.
• To have low noise priority operation, select the
lowest fan speed ( ).
To adjust vertical airfl ow
AIR SWING
direction
(CS-TZ9SKEW, CS-TZ12SKEW,
CS-TZ15SKEW, CS-TZ18SKEW)
(Remote control display)
• Keeps the room ventilated.
• In COOL/DRY mode, if AUTO is set, the fl ap swings
up/down automatically.
• Do not adjust the fl ap by hand.
To adjust airfl ow direction
AIR SWING
(CS-TZ24SKEW)
(Remote control display)
• Keeps the room ventilated.
• In COOL/DRY mode, if AUTO is set, the fl aps
swings left/right and up/down automatically.
• In HEAT mode, if AUTO is set, the horizontal fl ap is
fi xed at the predetermined position. The vertical fl ap
swings left/right after the temperature rises.
• If manual is set, the horizontal and vertical fl ap are
fi xed at the predetermined position.
• Do not adjust the fl ap by hand.
Auto Restart Control
• If power is resumed after a
power failure, the operation
will restart automatically
after a period of time with
previous operation mode
and airfl ow direction.
• This control is not applicable
when TIMER is set.
)

Operation conditions

Use this air conditioner under the following temperature range.
Temperature (°C)
COOL
HEAT
DBT : Dry bulb temperature
To set the timer
2 sets of ON and OFF timers are available to turn
ON or OFF the unit at different preset times.
1 2
ON
TIMER
OFF
1 Select ON or OFF timer Example:
• Each time pressed:
Cancel
2 Set the time
3 Confi rm
• To cancel ON or OFF timer, press
select respective
• If timer is cancelled manually or due to power
failure, you can restore the timer again by
pressing or
ON
then press .
SET
• The nearest timer setting will be displayed and will
activate in sequence.
• When ON Timer is set, the unit may start earlier
(up to 35 minutes) before the actual set time in
order to achieve the desired temperature on time.
• Timer operation is based on the clock set in the
remote control and repeats daily once set. For
clock setting, please refer to Quick guide.
Note
SLEEP
,
• Can be activated in all modes and can be
cancelled by pressing the respective button again.
Indoor CU-TZ15SKE, CU-TZ18SKE,
DBT WBT
Max. 32 23
Min. 16 11
Max. 30 -
Min. 16 -
WBT : Wet bulb temperature
3
SET
CANCEL CANCEL
OFF at 22:00
OFF
SET
or
ON
or then press
CANCEL
to select respective
OFF
CU-TZ9SKE, CU-TZ12SKE,
CU-TZ24SKE
DBT WBT
43 26
-10 -
24 18
-15 -16
to
OFF
.
or
9