Warning Signal; Replacing The Lamp; Closing The Door; Technical Data - AEG SKS98840F0 Notice D'utilisation

7.1 Warning signal

The warning signals of the control and
signalling system of the appliance are
displayed on the Visual Display.
The system will give out a signal if:
•
An error has occurred in the operation
of the appliance. In case the electronic
system of the appliance cannot identi-
fy the real temperature a sign will ap-
pear on the temperature display.

8. TECHNICAL DATA

Dimension of the recess
Voltage
Frequency
The technical information are situated in
the rating plate on the internal left side
of the appliance and in the energy label.

9. INSTALLATION

WARNING!
Read the "Safety Information"
carefully for your safety and cor-
rect operation of the appliance
before installing the appliance.
• Until the staff of the customer service
arrive at the spot and solve the prob-
lem, the appliance will continue oper-
ating with the help of a spare pro-
gram.

7.2 Replacing the lamp

The appliance is equipped with a long-
life LED interior light.
Only service is allowed to replace the
lighting device. Contact your Service
Center.

7.3 Closing the door

1.
2.
3.
Height
Width
Depth
9.1 Positioning
This appliance can be installed in a dry,
well ventilated indoor, also in a garage
or cellar, but for optimum performance
install this appliance at a location where
the ambient temperature corresponds to
Clean the door gaskets.
If necessary, adjust the door. Refer
to "Installation".
If necessary, replace the defective
door gaskets. Contact the Service
Center.
880 mm
560 mm
550 mm
230 V
50 Hz
ENGLISH
29