easydriver c-Go Instructions D'assemblage Et Mode D'emploi page 16

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

6. Anzeige
The power supply/battery charger operates auto-
matically. The operation mode can be read from the
LED indications. Depending on the installation and
Orange LED
Off
Blinking slowly*
Off
On
Off
On
Blinking quickly**
*2 seconds on / 2 seconds off
**0,5 seconds on / 0,5 seconds off
7. Notes
› Prevent deep discharging of the batteries. The
battery life will be reduced significantly. Charge a
deep discharged battery as soon as possible
› Do not separate the charger from the battery until
the battery has been fully charged
› If the battery is not charged over a longer period
of time, charge the battery once a month using the
c-Go unit. Self-discharge and connected consu-
mers will be a burden on the battery
16
Green LED
Mains available?
Off
No
Blinking slowly*
No
Blinking slowly*
Yes
Blinking slowly*
Yes
On
Yes
On
Yes
Blinking quickly**
Yes
the charge level of the battery the following indica-
tions can occur:
Description:
No vehicle connected or voltage of
the vehicle battery too low.
Battery and/or 12 V board system will
be charged by the vehicle.
Battery is charging
(no vehicle connected)
Battery is charging (vehicle connected)
Battery fully charged
(no vehicle connected).
c-Go in trickle charging mode
Battery fully charged
(vehicle connected).
c-Go in trickle charging mode
Error. See chapter "Troubleshooting"
› Do not charge the batteries below 0 °C. Move the
battery to a warmer place and start the charge
› Make sure the ventilation orifices (20 A unit) are
not blocked. Do not place any objects directly on
top of the c-Go
› Clean the charger using a slightly moist cloth only

Publicité

Table des Matières
loading

Table des Matières