Mounting And Installation - easydriver c-Go Instructions D'assemblage Et Mode D'emploi

4. Mounting and installation

The charger is not designed for outdoor use. Use
only indoors in sufficiently ventilated rooms. Al-
ways provide for sufficient cooling. Insufficient coo-
ling will automatically lead to a reduction in output
power. Do not expose the unit to direct sunlight.
The 20 A version is equipped with an additional
internal low-noise fan. The fan will be activated
automatically when the temperature inside the unit
reaches a specific level.
The c-Go is equipped with an EU type plug
for connection to the main power supply with
220 – 240V/AC 50 Hz.
Do not connect the c-Go charger to the
power supply before the battery has
been connected.
Connect (A) to the battery or board system of your
vehicle. For this purpose use the cables included in
the delivery. Connect the red cable to +12 V and the
black cable to the ground connector.
14
For a fixed installation we recommend to use the
cable with the ring cable lugs. The cable with the
crocodile clamps should only be used when char-
ging the battery outside the vehicle (e. g. at home).
Start by disconnecting the c-Go
from the mains supply first, before
disconnecting the battery.
The orange (B) wire may be connected as an option.
If connected to the vehicle's steady positive connec-
tor both batteries will run in a parallel configura-
tion as soon as the voltage of the vehicle battery
exceeds 12.6 V and the c-Go charger is disconnec-
ted from the mains supply. The c-Go will automati-
cally separate the two batteries again to permit the
towing vehicle to start up. In this context the ground
connectors of the two batteries must be connected
to each other.