easydriver c-Go Instructions D'assemblage Et Mode D'emploi page 11

Index
1. Product description
2. Safety advices
3. Scope of delivery
4. Mounting and installation
5. Changing the charging characteristics
1. Productdescription
The c-Go 12 V battery charger series was designed
for the fully automatic charging of 12 V lead-acid
batteries. It may be used for the charging of gel
and AGM batteries. The charger is equipped with a
highly efficient switching mode power supply. The
charging operation and control of the unit is ef-
fected via microcontroller. The use of high-quality
components ensures a high level of efficiency.
The loader was designed for continuous battery
connection, while other consumers are connected to
the battery at the same time. Make sure the energy
consumption of the additional consumers will not
exceed the maximum loading current or the battery
may not be charged. When the safety regulations of
this manual are observed and the charger is ope-
rated in compliance with this manual, the batteries
will be fully charged.
On top of that, the charger may be used for voltage
supply purposes without a battery connected.
Depending on the version this mode will provide a
voltage of 13.2 V and a maximum output current of
10 A or 20 A, respectively.
Caution: In the voltage supply mode
the charger is not protected against
reverse polarity.
6. Display
7. Notes
8. Troubleshooting
9. Technical specifications
Read the safety advices carefully
Read the user manual before using
the battery charger.
For indoor use only
Do not use the battery charger in a
wet environment or in the rain.
The battery charger and batteries
are not to be discarded with normal
household waste. Dispose properly
according to the local regulations.
The battery charger is a class II
appliance (double insulated)
The battery charger complies with
the European CE requirements.
11