Test Running; Service; Filterchange - Dustcontrol S 11000 Notice Originale

Test Running

Check that the vacuum producer is correctly installed
and inlet and outlet connected to the duct system. The
tubing between the fi lter unit and vacuum producer must
be free from particles. Objects in the vacuum producer
can cause failure.
Check discharge arrangement. No leakage can be al-
lowed.
Cleaning of the fi lters

Service

If the system does not give full suction after fi lter clea-
ning, it is recommended that the fi ne fi lters are changed.
Use only original fi lters.
The condition of the fi lters can be checked by measur-
ing the pressure drop over the cleaned fi lters with a

Filterchange

The fi lters should be changed at least once per year.
Only original fi lter is allowed. Use breathing protection
during the fi lter change. Do not expose unprotected
persons to harmful dust.
- Turn off and lock the disconnect of the vacuum
producer.
- Use breathing protection.
- Lift off the top of the fi lter unit.
- Lift out the fi lters and seal them in a plastic sack.
- Lift in the new fi lters, and connect the top.
If the extracted dust is collected in a plastic bag, the bag
should be changed when the dust level is 5 cm under
the plastic fl ap at the bottom of the fi lter unit. The plastic
sack must be sealed when removed from the fi lter unit.
If the dust is collected in a container, it should be chan-
ged or emptied before it is completely full.
S 11000, S 21000, S 32000, S 34000, S 46000
S 11000 EX, S 21000 EX, S 34000 EX - 33
The fi lters of the dust separator are cleaned automati-
cally.
This is done at different times, depending on
confi guration of the system.
When the fi lter is cleaned a number of very clear air
pulses, with a few seconds interval, should be heared.
manometer (Part No 8283). If the manometer registers a
value higher than 3 - 4 kPa the fi lters should be chan-
ged.
Some time after the installation there should be a
follow-up check on all screws and nuts.
Filter Part No
S 11000 4292
S 11000X
4284
S 11000 EX 429206
S 21000 4284
S 21000 EX 429206
S 32000 4292
S 34000 4292
S 34000X 4284
S 34000 EX 429206
S 46000 4284
Number
1
1
1
1
1
2
4
4
4
6
Part No 94160-G