Prog Ra M Min Gco Ffee D Oses - Victoria Arduino EAGLE ONE PRIMA Manuel D'instructions

Switch ON the machine
by pressing the switching
button situated on
bottom right side.
Programming can be done
from the keyboard on the
machine, but also using the
mobile APP (see chapter 8).
PROGRAMMING
1A 1B 1C
7.1
the
PRO G RA M MING
CO FFEE
TEM PERATU RE
Press and hold the 1A and
1
1C buttons for 5 seconds,
to enter the first level pro-
gramming menu. Access
is confirmed when the
button 1B LED light starts
blinking.
Press the 1A and 1C but-
2
tons to decrease or in-
crease the temperature.
3 Display will show the set
temperature.
To confirm and exit from
4
the procedure, press the
central button 1B for 3
times.
E AG L E O N E P R I M A | L I B R E T TO I ST R UZ I O N I - U S E R H A N D B O O K - M A N U E L D 'I N ST R U CTI O N S | 53
1A 1B 1C
7.2
PROG RA M MIN G
CO FFEE D OSES
Press and hold the 1A and
1
1C buttons for 5 seconds,
to enter the first level pro-
gramming menu. Access
is confirmed when the
button 1B LED light starts
blinking.
Press button 1B to enter
2
the second level pro-
gramming menu
cess is confirmed when
the message "dS"
shown on the display and
button 1B starts blinking).
3 Press the desired coffee
button to initiate deliv-
ery. The pressed button
remains lit and the deliv-
ery time (in seconds) is
shown on the display.
4 Press the coffee button
again to stop delivery
and store the dose in the
memory.
5 To confirm and exit, press
the central button 1B for 2
times.
(ac-
is