Manual Release Mechanism; Electronic Programmer - Cardin SL Série Mode D'emploi

INSTRUCTIONS FOR POSITIONING THE UNIT
7
- The geared motor unit has been assembled in the fac-
tory to be fitted to the LEFT SIDE of the gate (internal
view). To install the motor to the RIGHT of the gate
8 S1

MANUAL RELEASE MECHANISM

Manual release is carried out with the power to the motor interrupted due to
a power failure. To release the gate use the manual release key supplied with
the unit. The key should be kept inside the house in an easily accessible place
or stored with the unit itself.
8
A
To release the unit
A
T-shaped pin, then rotate the key through 90 degrees in the direction indi-
C
the gears from the motor allowing you to manually manoeuvre the gate by
pushing lightly on it.
To relock the unit
Follow the above instructions in reverse order rotating the key through 90
Attention! Never use the manual release mechanism while the gate
is in operation. If you release the gate and then give a movement
command the following symbol appears on the display
Access to the electronic card
90° as shown in fig. 8.
Caution! Before opening the cover make sure that the power
has been switched off at the mains.

ELECTRONIC PROGRAMMER

Electronic programmer for a dc motor with an incorporated radio receiver
card, which allows the memorisation of 300 user codes
page 20).
The motor rotation speed is electronically controlled, starting slowly and
increasing in speed; the speed is reduced as it nears the travel limit so as to
enable a controlled smooth stop.
Programming is carried out using one button and allows you to set the current
sensor and the entire gate travel distance.
The logic carries out position control using an encoder.
The intervention of the anticrush/antidrag sensor during the closing and opening
stages causes a brief (10 cm) travel direction inversion then a block.
ON
1 2 3 4 5 6 7 8
ON
F
G
9 0
B
C
D
B
D
A
G
433.92 MHz series transmitters.
programmer, release the gate (manual release mechanism) and
move it manually, checking that it moves smoothly and has no
unusual points of resistance.
indicated by the warning lights pre-flashing for 10 seconds, and by
the symbol
ing
system, which is used to block the motor in emergency conditions;
however this system is not active during the first second of each
manoeuvre.
Do not therefore attempt to physically block the door during these
stages.
If you need to check the status of the fuses, disconnect the power
supply to the programmer; reconnect it only after having re-inserted
the fuse.
The presence of the electrical input monitoring system does
not exclude the need to install photoelectric cells or other safety
devices which are foreseen by the local standards and regulations
in force.
The geared motor unit has been assembled in the factory to be
for positioning the unit
For the correct operation of the programmer the incorporated
batteries must be in good condition: the programmer will lose the
position of the gate in case of blackouts when the batteries are flat,
the alarm will sound and automatic repositioning will take place .
Check the good working order of the batteries every six months
frequency rated on the data plate conform to those of the mains
supply.
must be installed between the unit and the mains supply.
ends of cables which are to be inserted into the binding posts; use
cables marked T min 85°C and resistant to atmospheric agents.
the wire and the insulating sheath are tightly fastened (a plastic
jubilee clip is sufficient).
ELECTRICAL CONNECTION 230 Vac
.
wires.
230 Vac mains power supply
terminal board:
- connect the live to post 1
- connect the earth to post 5
- connect the neutral to post 2
the power supply to the programmer; reconnect it only after
having re-inserted the fuse.
16
IMPORTANT REMARKS
before powering up the
automatic reposition-
Battery check
3 mm between the contacts
230Vac
N L
TS
PS
TS
L
N
F1
instructions