Software Upgrade; Info; Backlight; Aux: Auto-Standby - Hama IR110 Mode D'emploi

5.2.3.3 Software Upgrade

A new update is released from time to time for the radio. If
the radio is connected to the internet you will automatically
receive notification that a new update is available for
installation. If you have deactivated automatic updates, you
can also use this menu item to check manually for updates.
To this end select the entry ‚Check now' (System settings
> Software Upgrade). The radio then checks the update
server for a new update. If an update is available, the radio
requests confirmation that it should install the update.
Note
It is recommended to leave the ‚Auto-check setting'
setting activated as an update often contains
improvements and bug fixes that are necessary for
the smooth operation of the radio. In addition, the
functionality of the radio is often extended, which can
further improve the convenience of using the radio.

5.2.3.4 Info

No settings can be made under this menu item. If you
contact Customer Service you may be asked for the
information here, which contains the current hardware and
software details. The Radio ID specified here can also be
found on the online portal of Frontier Silicon (http://www.
wifiradio-frontier.com) if you have registered your radio
there.

5.2.3.5 Backlight

This menu item enables you to define the brightness
of the Backlight. A difference is made between display
illumination during operation and in standby. Select menu
item "Operation Mode", the modes "HIgh, Medium and
Low" are available. The configuration in menu item Standby
Mode also enables you to set the time-out time in which
the display is completely illuminated in standby mode. If
standby illumination is set to a low brightness level, and if
operating mode is set to a high brightness level, you can
use the display at the operating mode brightness level for
the preset time-out time by pressing the [ENTER] button.
Once the time-out time has elapsed, the display switches
back to standby brightness.

5.2.3.6 AUX: Auto-Standby

After 60 minutes, the radio switches to standby mode by
default when it is connected to a smartphone, tablet PC
or MP3 player via the AUX connection. You can disable or
enable this setting again in this menu.

5.2.4 Other internet settings

You can make other settings in addition to Network already
mentioned. You can access Network as follows:
[MENU] > System settings > Network

5.2.4.1 View settings

Here you can find an overview of all of the existing network
settings currently used by the radio, or that have been set
up.

5.2.4.2 NetRemote PIN Setup

The radio can be controlled using the Hama Smart Radio
application. For this, you have to have installed the
application (app) on your smartphone or tablet PC and that
the radio is in the same network as your device. The PIN
saved in the radio is to increase security and prevents other
users from connecting with the radio. If the app is started
on your Android or iOS device and it tries to connect with
the radio, a window will appear on your smartphone or
tablet PC requiring you to enter the PIN. Enter the PIN
saved here to establish a connection between the radio and
the control device.
The radio PIN is set to "1234" by default, it can be changed
by turning the navigation controller and pressing the
[ENTER] button. Confirm your entry with the "OK" button
or delete the previous entry by pressing the "BKSP" button
on the display.

5.2.4.3 Network profile

The radio saves profiles that have been used previously,
and you can access them in different installation locations.
These profiles relate to WLAN networks that the radio has
successfully dialled into. When the radio tries to connect
with the network, it automatically checks these profiles
and uses the saved data. To delete these profiles, select
the profile you want to delete by turning the navigation
controller and pressing the [ENTER] button. Confirm the
prompt querying if you want to delete the profile with
"Yes". A profile that is currently active, or that is in use,
cannot be deleted.
15