EINHELL Bavaria BHS 75 Mode D'emploi page 8

Anleitung BHS 75 SPK 1
GB
1. Description
1. Handle
2. Data plate
3. ON/OFF switch
4. Locking button for ON/OFF switch
5. Locking lever for cutting depth setting
6. Power cord
7. Splitter
8. Swing guard hood
9. Screw
10. Soleplate
11. Flange
12. Saw blade
13. Parallel stop
14. Locking screw for parallel stop
15. Locking lever for miter setting
16. Connection for dust extractor
17. Additional handle
18. Actuator for swing guard hood
19. Laser attachment
20. Locking button
Please read these instructions carefully and pay
particular attention to the safety regulations. Keep the
instructions together with the circular saw.
2. Technical data
Voltage 230 V ~ 50 Hz
Power rating
Idle speed
Cutting depth at 0°
Cutting depth at 45°
Saw blade 210 mm dia.
Saw blade mount
Saw blade thickness
Sound pressure level LPA 97,2 dB(A)
Sound power level LWA 110,2 dB(A)
Vibration a
W
Weight
Totally insulated
Laser class
Laser wave length
Laser output
Laser module power supply 2 x 1,5 V (AAA)
3. Applications
The hand-held circular saw is designed for sawing
straight cuts in wood, in materials similar to wood,
and in plastics.
8
10.09.2004 11:04 Uhr Seite 8
4. Safety regulations
The corresponding safety information can be
found in the enclosed booklet.
Important!
Laser radiation
Do not look into the beam
Laser class 2
Protect yourself and your environment from accidents
by taking the appropriate precautionary measures.
Do not look directly into the laser beam with the
naked eye.
Never look directly into the laser path.
Never direct the laser beam at reflecting surfaces
or persons or animals. Even a low output laser
beam can inflict injury on the eye.
Caution: It is vital to follow the work procedures
described in these instructions. Using the tool in
any other way may result in hazardous exposure
to laser radiation.
Never open the laser module.
When the device is not going to be used for
an extended period of time, the batteries should
be removed.
5. Working with the hand-held
circular saw
1800 W
Always hold the circular saw firmly.
5000 rpm
The hinged guard hood will be pushed back
75 mm automatically by the workpiece.
Never apply force! Advance the circular saw gently
53 mm
and steadily.
The off-cut piece should be to the right of the
30 mm dia.
circular saw so that the wide part of the base plate
2,5 mm
is supported over its entire surface.
When sawing along a marked line, guide the
circular saw along the corresponding groove.
Clamp small pieces of wood securely before
< 2,5 m/s 2
sawing. Never hold them in your hand.
6,4 kg
Always observe the safety regulations! Wear
goggles!
II /
Do not use defective saw blades or blades with
2
cracks or flaws.
650 nm
Do not use flanges or flange nuts with a hole
≤ 1 mW
which is larger or smaller than that of the saw
blade used.
Do not try to stop the saw blade with your hand or
by applying pressure to the side of the blade.
The hinged guard must not jam and must return to
its original position once work is completed.
Before plugging in the circular saw, check that the
hinged guard is functioning properly.