EINHELL Bavaria BHS 75 Mode D'emploi page 10

Anleitung BHS 75 SPK 1
GB
Important!
Wear ear muffs and goggles.
1
2 A B
Parallel cuts
1. Release the lock screw 1.
2. For 90° cuts, adjust the parallel stop 2 using the scale on groove
A, for 45° cuts adjust the parallel stop 2 using the scale on groove
B. Observe the saw blade width.
3. Tighten the lock screw.
Important!
First make a trial cut.
Adjustment of the shoe (cutting angle)
1. Release the lock screw 1
2. Adjust the shoe to the desired angle between 0 and 45°.
3. Tighten the lock screws 1.
10
10.09.2004 11:04 Uhr Seite 10
Adjustment of the cutting depth
1. Release the lock screw (1).
2. Swing the shoe downwards.
3. Adjust the cutting depth using the scale.
The saw teeth must project approx. 2 mm out of the wood.
4. Tighten the lock screw.
Important!
Pull out the plug before
making any changes to the
circular saw!
1
2
1
9
4
Sägeblatt wechseln
1. Open swing guard hood 1 and hold in place
2. Changing the saw blade is easy thanks to the spindle lock.
Press the locking button (20) and allow the saw blade to lock into
place
3 Undo the screw
4. Remove flange 4 and the saw blade in a downwards direction
5. Clean the flange and insert the new saw blade.Pay attention to
the running direction (see arrow on the guard hood)
6. Tighten the screw, ensure smooth running of the blade
1
20