Identifying The Channel And/Or Appliance; Assign The Transmitter To A Free Channel Or Change The Channel; Registering A New Transmitter On The Receiver - AKG DMS Tetrad Mode D'emploi

Setting up

Identifying the channel and/or appliance

Assign the transmitter to a free channel or
change the channel
Registering a new transmitter on the
receiver
14
The provided transmitter is preconfigured to channel 1 on the receiver.
Use the identification feature to check
the channel on the receiver assigned for a transmitter and

the connected transmitter for a channel on the receiver.

Briefly press Connect (18) on the transmitter or receiver.
The Status LEDs (15) on the same channel of the transmitter and receiver flash

green.
This identification feature can also be used during operation without causing any disturbance or
interruption.
NOTE
The following instructions apply for the assignment of a free channel and for changing a channel.
Actions 3 and 4 can be started from the transmitter and receiver. In this example, they are
started from the receiver.
1) Pull the battery compartment cover (16 / 24) down and off the transmitter.
2) Switch on the transmitter and receiver.
3) Press Connect (3) on a free channel of the receiver and hold down until the Status LED (5)
starts to flash after approximately 2 seconds.
You need to confirm with the transmitter within the next 30 seconds.

4) Hold down Connect (18) on the transmitter until the Status LED (15) lights up green.
The status LEDs on the transmitter (15) and the receiver (5) light up green once

assignment has been successful.
The actuated settings are saved. This means that you can simply continue using the DMSTetrad
system with the last-used settings (channel assignments) the next time you switch on.
NOTE
Duplicate channel assignment is not possible with the DMSTetrad system!
This means that you cannot assign two (or more) transmitters to one channel on the receiver.
The LED of the connected transmitter is lit green; the LED of the transmitter that is not connected
flashes green. Please assign a free channel to this transmitter.
NOTE
Make sure you do not assign the same channel twice!
Start the registration process with the transmitter: Transmitter -> Receiver
1) Pull the battery compartment cover (16 / 24) down and off the transmitter.
2) Switch on the receiver.
3) Press and hold Connect (18) on the transmitter while pressing the On/Off button (17) until
the Status LED (15) starts to flash.
Within the next 30 seconds, the status LED (15) flashes rapidly and you need to

confirm with the receiver.
4) Hold down Connect (3) on a free channel of the receiver until the Status LED (5) lights up
green.
The status LEDs on the transmitter (15) and the receiver (5) light up green after

successful registration.
DMSTetrad