Min/Turb - Schiltknecht Messtechnik ThermoAir3 Mode D'emploi

ThermoAir3
Keys: Functions:
Mean value measurements for the parameters Flow, Temp or
RH can be performed over a certain averaging time with the
key "Rep".
An averaging time of 6 seconds is pre-programmed.
During the measurement, the remaining seconds are counted off,
after which the mean value over this time is indicated. (The current
value can be indicated during the mean value measurement with
the key "Flow/RH" or "Temp").
With Mini2Logger connected and switched on, by pressing the
"Rep" key for a longer time the Rep measurement is automatically
repeated and the data are transferred to the Min2Logger between
two Rep measurements.
The maximum values of the parameters Flow, Temp or RH are
indicated with the key "Max".
In the case of measurements via the mean value ("Start/Stop" key
or "Rep" key) the maximum values are indicated with the "Max"
key.
The minimum values of the parameters Flow, Temp or RH or
the grade of turbulence of the flow are indicated with the key

"Min/Turb".

In the case of measurements via the mean value ("Start/Stop" key
or "Rep" key) the minimum values are indicated with the "Min/Turb"
key, through 2 x pressing of the key "Min/Turb" the grade of
turbulence of the flow will be indicated in % (only in Rep-Mode)
34 Schiltknecht Messtechnik AG