Dry Vacuum Operation - ArmorAll AA155 Manuel D'utilisation

• Do not use the vacuum while it is mounted on the wall mount support.
• Empty the tank before mounting the vacuum on the wall.
11. Make sure the rack is level and mark the hole locations. Make a 1/8-inch diameter pilot hole in each
marked location. Align the two screw holes so that they are over a stud and secure the mounting
support to the wall studwith the two screws provided. (fig. 11)
12. Place the wet/dry vacuum cleaner onto the support. (fig. 12)
POLARIZED PLUG
To reduce the risk of electrical shock, this appliance has a polarized plug (one blade wider than the other).
This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug.
If it still does not fit, contact a qualified electrician to install the proper outlet. Do not change the plug in any
way. Double insulation
supply system.

DRY VACUUM OPERATION

DRY VACUUMING
WARNING:
BE SURE TO READ, UNDERSTAND, AND APPLY, INFORMATION ENTITLED 'SAFETY
INSTRUCTIONS & WARNINGS'. DO NOT VACUUM IN AREAS WITH FLAMMABLE GASES, VAPORS,
OR EXPLOSIVE DUSTS IN THE AIR. FLAMMABLE GASES OR VAPORS INCLUDE BUT ARE NOT
LIMITED TO: LIGHTER FLUID, SOLVENT TYPE CLEANERS, OIL-BASED PAINTS, GASOLINE,
ALCOHOL OR AEROSOL SPRAYS. EXPLOSIVE DUSTS INCLUDE BUT ARE NOT LIMITED TO:
COAL, MAGNESIUM, GRAIN, OR GUN POWDER. TO REDUCE THE RISK OF HEALTH HAZARDS
FROM VAPORS OR DUST, DO NOT VACUUM TOXIC MATERIALS.
1. Verify that the power cord is disconnected from the outlet. (fig. 1)
2. Make sure the filter is completely covering the filter cage. (fig. 2) Your Wet/Dry Vac should come with
the reusable cloth filter pre-installed. For installation instructions see page 10.
3. Place the power head back on the collection tank, and secure it by locking the latches. (fig. 3 & 4)
OPERATING INSTRUCTIONS: DRY VACUUMING
4. Insert the larger end of the hose into the vacuum port on the power head. Push the desired nozzle onto
the free end of the hose. (fig. 5 & 6)
5. Ensure the switch is in the 'O' OFF position before plugging into the power supply. (fig. 7)
6. Plug the power cord into the outlet. (fig. 8)
7. Turn the motor on by flipping the switch to the 'I' ON position and begin vacuuming. (fig. 9)
8. Once you have completed vacuuming, flip the switch to the 'O' OFF position and unplug the power cord
from the outlet.
O = OFF I = ON
DO NOT USE THE REUSABLE CLOTH FILTER FOR LIQUID VACUUMING.
eliminates the need for the three wire grounded power cord and grounded power
7