Cleaning The Milk System - Siemens CT636LE.1 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

■ Empty, clean and dry individual parts�
F
Important: The drip tray and coffee
grounds container should be emptied
and cleaned every day in order to
prevent deposits�
■ Remove the ground coffee drawer, clean
under running water and dry well�
■ Wipe and dry the inside of the appliance
(support, drip tray and the ground coffee
drawer) and collecting tray�
■ Replace the dried parts, e.g. the ground
coffee drawer.
L
Do not put the following parts in
the dishwasher:
Accessory drawer, water tank, lid of the
water tank, beverage outlet cover, bean
container, lid of the bean container, metal
connecting element, ground coffee drawer,
protective cover of the brewing unit and the
milk container�
M
The following parts may be cleaned
in the dishwasher:
Drip plate, collecting tray, drip tray, drip tray
cover, coffee grounds container, milk tubes,
suction pipes, individual parts of the bever-
age outlet, measuring spoon and individual
parts of the milk container lid�
F
If the appliance is cold when
switched on, or if it is switched off
after dispensing coffee, it rinses
automatically� The system is there-
fore self-cleaning�
Care and daily cleaning
F
Important: If the appliance is not
used for a lengthy period (e�g�
while you are on holiday), clean
the entire appliance thoroughly,
including the milk system, the ground
coffee drawer and the brewing unit
before use�

Cleaning the milk system

The milk system is automatically cleaned
with a short jet of steam directly after pre-
paring a milk drink�
F
Tip: For particularly thorough clean-
ing, the milk system can be addi-
tionally rinsed with water (see the
section "Rinsing the milk system").
Important: Clean the milk system
manually every week and, if
required, also more often (see the
section "Cleaning the milk system
manually")�
B
Risk of burns!
The beverage outlet gets very hot�
After use, always let it cool down
before you touch it�
Rinsing the milk system
■ Press button E and select
"Rinse milk system" with the rotary
selector�
■ Press C to start the
programme�
■ Open door and remove suction pipe from
the milk tube�
■ Wipe the suction pipe and insert the end
of the suction pipe into the hole on the
coffee grounds container.
■ Close the door� Be careful not to jam the
milk tube�
en
47

Publicité

Table des Matières
loading

Table des Matières