Asco joucomatic POSIMATIC 606 Série Manuel D'installation page 23

INSTALLATION
R (exhaust) ................................................................... 21
Range control ............................................................... 14
RANGE FUNCTN ................................................... 12, 14
Response threshold ...................................................... 14
Flow restrictors, integrated ............................................. 9
Run (initialisation) ........................................................... 9
Run initialisation ............................................................. 9
RV (non-return valve) ................................................... 21
Safety ............................................................................. 4
SETP DIRECTN ..................................................... 12, 15
SETP FUNCTN ...................................................... 12, 16
SETP RAMP ........................................................... 12, 16
Setpoint direction .......................................................... 15
Setpoint function ........................................................... 16
Setpoint input, selection of ............................................ 18
Setpoint ramp ............................................................... 16
SETPOINT ..........................................................9, 12, 13
SOFT RELEASE .................................................... 13, 18
Software version ........................................................... 18
SPLIT END ............................................................. 12, 16
Split range .................................................................... 16
SPLIT START ......................................................... 12, 16
Standardisation of manipulated variable ....................... 17
Startup ............................................................................ 8
Storage ........................................................................... 3
Symbols.......................................................................... 3
in accordance with the EU directive for machinery 89/392/EEC Annex II B
We hereby declare that the device described in this installation manual is intended for incorporation into or assembly with
other machinery and that it must not be put it into service until the machinery into which it is to be incorporated has been
declared in conformity with the provisions of the EU directive 89/392/EWG.
Handling, assembly and putting into service and all settings and adjustments must be carried out by authorised
qualified personnel only.
This product complies with the essential requirements of the EMC Directive 89/336/EEC as amended. It is CE-approved. A
separate Declaration of Conformity is available on request.
A separate Declaration of Incorporation relating to the EU Directive 89/392/EEC Annex II B is available on request. Please
provide ordering code and serial numbers of products concerned.
R
S
Manufacturer's Declaration
Technical data............................................................... 19
Terminal assignment ....................................................... 7
Tight closing with manipulated variable ......................... 15
Transport ........................................................................ 3
X-DIRECTION ........................................................ 12, 13
X-DISPLAY ............................................................. 13, 17
POSIMATIC
T
X
2 3