2Factory Settings (Positioner Assembled To Valve); Operating Modes; Automatic Mode (A: Auto); Manual Mode (B: Manual) - Asco joucomatic POSIMATIC 606 Série Manuel D'installation

POSIMATIC
7.2.2 Factory settings (positioner assembled to valve)
„A: AUTO" is displayed. The positioner is ready for use.
If you wish to drive the valve by hand, press the
„B: MANUAL" is displayed.
The value can be adjusted with the + and – keys and the valve can be driven into the desired position with the
The positioner must be newly initialised after each replacement of valve or diaphragm. For this purpose call the menu
„2: INIT ALL" and proceed as described under 7.2.1.
For „control function 2" set the parameter 24:SETP DIRECTN to INVERS.
8.

Operating modes

8.1

Automatic mode (A: AUTO)

The automatic mode is the standard operating mode. The initialised positioner reacts automatically to setpoint changes
and sets the valve into motion accordingly .
The + and – keys do not have any function in this operating mode.
The actual position (x) is displayed in percent together with a bar graph in the upper readout.
In the lower readout, the current operating mode is displayed on the left and the current setpoint (w) is displayed in percent
on the right.
8.2

Manual mode (B: MANUAL)

→ → → → →
Press the key to access menu item „B: MANUAL".
The valve can be driven by hand in the manual operation mode. The value can be adjusted with the + and – keys and the
valve is driven into the desired position with the
8.3

Configuration (C: CONFIG)

→ → → → →
Press the key to access the configuration settings (C: CONFIG).
1 0
→ → → → →
key once.
→ → → → →
key.
INSTALLATION
→ → → → →
key.