Moon Phases; Backlight - Hama EWS-200 Mode D'emploi

6.6 Outdoor temperature alarm
• Repeatedly press the CH button (25) to select the measuring
station channel (7) for which you would like to set an alarm.
• Press and hold the ALERT button (26) for approx. 3 seconds
until the outdoor temperature display (8) begins to flash.
• The symbol for the lower limit value
limit value (8) flashes.
• Press the UP button (23) or the DOWN/MEM button (24)
to set the displayed limit value and confirm your selection by
pressing the ALERT button (26).
• Then repeat this procedure for the upper limit value .
• If you do not make an entry for 30 seconds, the device
automatically exits the settings mode and the settings you
made are saved.
• Repeatedly press the ALERT button (26) to activate/
deactivate the outdoor temperature alarm. The alarm symbol
(20) will appear/not appear.

6.7. Moon phases

The base station indicates the current moon phase (14) with the
following symbols:
Display (14)
6
is displayed and the
Moon phase
New moon
Waxing crescent
Waxing half moon
Waxing moon
Full moon
Waning moon
Waning half moon
Waning crescent
6.8 Comfort range
The base station displays the following comfort ranges based
on the ration between the current room temperature and room
humidity:
Display (6)

6.9 Backlight

Note – Backlight
If you press the SNZ/LIGHT button (27), the display will light
up for approx. 10 seconds.
6.10. Low battery capacity
As soon as the (2/21) battery symbol appears on the display
of the base station, the capacity of the batteries in the base/
measuring station is very low. Replace the batteries immediately.
Note – Replacing the batteries
• Note that the stations have to be resynchronised each
time after you change the batteries in the measuring or
base station.
• To do this, remove the batteries from the other station and
then reinsert them, or change them as required.
7. Care and Maintenance
Only clean this product with a slightly damp, lint-free cloth and
do not use aggressive cleaning agents. Make sure that water
does not get into the product.
8. Warranty Disclaimer
Hama GmbH & Co KG assumes no liability and provides no
warranty for damage resulting from improper installation/
mounting, improper use of the product or from failure to observe
the operating instructions and/or safety notes.
Comfort range
– Pleasant –
Ideal temperature and humidity
– Moist –
Humidity too high
– Dry –
Ambient air too dry