Overview Of The Components; General Safety Instructions - AEG SRC 4306 CD Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 12

General safety instructions

Read the operating instructions carefully before putting the
appliance into operation and keep the instructions including the
warranty, the receipt and, if possible, the box with the internal
packing. If you give this device to other people, please also pass
on the operating instructions.
To avoid the risk of fi re or an electric shock, you should not
expose the device to rain or moisture. Consequently, do not
use the device in the immediate vicinity of water - for examp-
le near a bath tub, a swimming pool or in a damp cellar.
Use the device only for the intended purpose.
Only connect the device at a properly installed plug socket.
Pay attention that the specifi ed voltage corresponds to the
voltage of the plug socket.
When using external mains supply, pay attention to the
correct polarity and voltage. Always place the batteries in
the correct direction.
Assemble the device in such a way that the available
ventilation openings are not covered.
Never open the housing of the device. Incorrect repairs can
constitute a considerable risk for the user. Should the device
become damaged, in particular the mains supply cable, do not
operate the device any longer, but rather have it repaired by an
expert. Check the mains supply cable regularly for damage.
For safety reasons a broken or damaged mains lead may
only be replaced by an equivalent lead from the manufactu-
rer, our customer service department or a similary qualifi ed
person.
If the device is not used for a longer period, remove the plug
connector from the plug socket or take out the batteries.
These symbols may be found on the machine and are intended
to indicate the following:
The lightning symbol should advise the user of parts
in the inside of the device which carry dangerously
high voltage levels.
The symbol with an exclamation mark should advise
the user of important operation or maintenance
instructions in the accompanying documentation.
Devices bearing this symbol work with a „class 1
laser" for tracing the CD. The built-in safety switches
should prevent the user being exposed to dange-
rous laser light, which is invisible to the human eye,
when the CD compartment is opened.
Under no circumstances should these safety switches be
bypassed or manipulated, as this could result in a danger of
exposure to the laser light.
32
05-SRC 4306 AEG 32

Overview of the Components

1 Set minutes (MINUTE)
2 Hour function key (HOUR)
3 Time setting function key (CLOCK SET)
4 Alarm function key (ALARM SET)
5 Wake-up interval (SNOOZE)
6 Function key for delayed switch-off (SLEEP)
7 Function key (ALARM SLEEP/OFF)
8 ALARM switch (1/2 /1+2)
9 Function selector switch (BUZZER/AUTO/OFF/ON)
10 TUNING control
11 Function selector switch (FM / MW / CD)
12 VOLUME (MIN/MAX) control
13
Headphone connection
14 LCD display
15 CD compartment
16 Tab for opening
17 I
/
I SKIP/SEARCH buttons
(forward/reverse search)
18
STOP button
19
II PLAY/PAUSE button
20 RANDOM button
21 PROGRAM/REPEAT button
22 DIMMER button
23 Throw-out antenna
24 Battery compartment
25 AC connection
26 Loudspeakers
Initial Use of the Radio Recorder/
Introduction
Please read the operating instructions carefully before
using the radio recorder for the fi rst time!
Select a suitable location for the radio recorder, such
as a dry, fl at, non-slip surface on which it is easy to
operate the machine.
Ensure that the radio recorder is suffi ciently ventila-
ted!
Insert the plug into a properly installed 230 V, 50 Hz
power socket. The time 0:00 fl ashes in the display.
Ensure that the voltage is the same as that indicated
on the model identifi cation plate.
Inserting the batteries (not supplied)
If there is a power cut or the mains plug has been remo-
ved from the power socket, the settings will be retained if
the power reserve batteries are inserted.
1. Open the battery compartment (24) on the bottom.
2. Connect a 9 V, E compound battery to the supply
connection. Please ensure the correct polarity.
3. Close the battery compartment again.
4. If the device is not used for a prolonged period of
time, please take the batteries out in order to prevent
leakage of battery acid.
Note: Do not dispose of batteries in the domestic waste.
Please return used batteries to the relevant collection
points or the shop where they were bought.
Never throw batteries into a fi re.
Headphone Socket
Please use headphones with a 3.5 mm jack, which
should be inserted in the
phones socket (13). The
loudspeakers (26) are then switched off.
10.03.2005, 12:13:15 Uhr

Publicité

Table des Matières
loading

Table des Matières