Cassette Operation - LENCO SCD-430RD Mode D'emploi

BASS BOOST SYSTEM
The BASS BOOST BUTTON controls the bass of the unit. Bass sound is
the lower frequency ranges of sound. The knob can be pushed to OFF
or ON position. When the BASS BOOST is on, the unit boosts
(increases) the sound output of the bass frequencies.
RADIO OPERATION
TUNING IN RADIO STATIONS
1. Slide the FUNCTION switch to select the desired wave band:
AM/FM ST..
2. Tune to required station by rotating the TUNING KNOB.
3. Rotate the VOLUME CONTROL to comfortable volume level.
4. Extend the TELESCOPIC ANTENNA to its full length if you are
listening to FM broadcasting. Gently move the unit back and forth
to get the best reception when you are listening to AM program,
or place the unit in an open place.
Note: The FM STEREO indicator will be on if you are receiving FM
stereo program.
5. Turn off the radio by switching the FUNCTION switch to
"TAPE/OFF" position

CASSETTE OPERATION

PLAYBACK OF CASSETTE
Be sure to tighten any slack tape in the cassette before use, using
either a pencil or a ball-point pen, simply insert the pen or pencil into
the center of spool and rotate to remove slackness. Depress the
STOP/EJECT button to open the cassette door.
Insert the cassette into the compartment with the open end facing
upwards and the full reel on the left hand side, push the cassette well
down and close the door, be sure not to touch the tape surface, Set
the FUNCTION switch to "TAPE" position and press the cassette PLAY
button. To stop playback, press the STOP/EJECT button once. To
release the cassette, press the STOP/EJECT button again.