Connecting To The Power Supply; Basic Operation; Radio Operation - LENCO SCD-650 Mode D'emploi

3. CONNECTING TO THE POWER SUPPLY

1. Connect the end of the detachable power cord to the unit rear panel AC~IN jack and the other end to
the AC outlet.
2. When you first plug the unit into the mains, the unit is OFF mode. The POWER INDICATOR LED is
off.
3. Slide the FUNCTION switch to different modes of operation to turn on the unit. The POWER
INDICATOR LED will light up. The LCD display will turn on when it is in CD/USB/AUX in models. In
FM modes, the LCD display is off.
4. DC CONNECTION
For DC operation, firstly remove the AC plug from the AC outlet and disconnect the AC cord from the
AC~IN jack. Then insert 6 pcs size C (UM-2) batteries into the battery compartment.
Since the unit will draw little power consumption even in OFF mode, it is suggested to uninstall the
battery when it is not used for a long time.
EN
UM2 (LR14) C SIZE 1.5V X 6 PCS
'C' SIZE, UM-2 1.5V

5. BASIC OPERATION

Slide the FUNCTION switch to select from "CD/USB/AUX" modes of CD playback/USB playback or AUX
in. Switch to "FM MONO" for FM radio mono mode and "FM STEREO" for FM radio stereo mode. To turn
off, slide it to the "OFF" position.
Volume Control
Turn the VOLUME CONTROL to change the sound loudness.
Adjusting the Telescopic Antenna
The antenna should be extended to ensure a good FM reception. Alter the antenna position for the best
reception.

6. RADIO OPERATION

1. Slide the FUNCTION switch to "FM MONO" or "FM STEREO" as desired, the POWER Indicator will
illuminate.
2. Turn the TUNING CONTROL to your desired radio station.
Always keep the antenna fully extended for best performance. Try to put your unit near an open window
until you get the best reception.
EN
UM2 (LR14) C SIZE 1.5V X 6 PCS
'C' SIZE, UM-2 1.5V
8