Technics SB-G90 Manuel D'utilisation page 14

Placing the speakers using the rubber feet
Attach the rubber feet (4 pcs) to the recesses on the base plates in advance. (
≥ Panasonic is not responsible for any accidents or damage caused by improper assembly or handling of the product. Do
not attach the accessories in any other way than instructed in this Owner's Manual.
≥ Each speaker weighs approximately 32 kg (71 lbs). Ensure that the work is done by at least two people. Be careful not to
catch your fingers or toes between the speaker and the floor or tip over the speaker.
≥ Since each rubber foot supports a weight of at least approximately 8 kg (17.6 lbs), the rubber feet may leave marks and
indentations on the installation location.
≥ Dragging the speaker along the floor may cause the rubber feet to peel off.
When changing the installation location of the speaker, always use at least two people to lift it.
To avoid floor damage, have a thick mat (or similar) available. Place it in the unpacking location in advance.
1 Place the speaker vertically on a thick mat (or similar).
2 Remove the protective bags (2 pcs) and the cardboard covering the speaker.
3 Hold the speaker so that it is tilted forward and move it to the installation location.
Hold the speaker so that your
hands do not touch the
speaker unit.
4 If the speakers wobble after being placed, place the spacers under the rubber feet. This will prevent the rubber feet from
wobbling on the installation surface.
14 (14)
11)
Rubber feet
Spacer