Optional Accessories - Makita 9910 Manuel D'instruction

Adjusting belt tracking
more than 8mm (5/16")
1
2
► 1 . Steel plate 2. Adjusting screw
Switch on the tool and make sure that the belt is aligned
properly. If the edge of the belt extends beyond the
edge of the steel plate or the edge of the belt retracts
more than 8 mm (5/16") away from the edge of the steel
plate, use the adjusting screw to adjust the belt tracking.
Dust bag
2
► 1 . Dust spout 2. Dust bag
Attach the dust bag onto the dust spout. The dust spout is tapered.
When attaching the dust bag, push it onto the dust spout firmly as
far as it will go to prevent it from coming off during operation.
When the dust bag is about half full, remove the dust bag
from the tool and pull the fastener out. Empty the dust bag of
its contents, tapping it lightly so as to remove particles adher-
ing to the insides which might hamper further collection.
NOTE:
• If you connect a Makita vacuum cleaner to this tool, more
efficient and cleaner operations can be performed.
OPERATION
Sanding operation
CAUTION:
• The tool should not be in contact with the workpiece
surface when you turn the tool on or off. Otherwise a
poor sanding finish or damage of the belt may result.
Hold the tool firmly with both hands. Turn the tool on
and wait until it attains full speed. Then gently place the
tool on the workpiece surface. Keep the belt flush with
the workpiece at all times and move the tool back and
forth.
Never force the tool. The weight of the tool applies ade-
quate pressure. Excessive pressure may cause stalling,
overheating of the motor, burning of the workpiece and
possible kickback.
To maintain product SAFETY and RELIABILITY, repairs,
carbon brush inspection and replacement, any other
maintenance or adjustment should be performed by
Makita Authorized or Factory Service Centers, always
using Makita replacement parts.
1
If you need any assistance for more details regard-
ing these accessories, ask your local Makita Service
Center.
•
•
Please refer to the annexed warranty sheet for the
most current warranty terms applicable to this product.
If annexed warranty sheet is not available, refer to the
warranty details set forth at below website for your
respective country.
United States of America: www.makitatools.com
Canada: www.makita.ca
Other countries: www.makita.com
5 ENGLISH
MAINTENANCE
CAUTION:
• Always be sure that the tool is switched off and
unplugged before attempting to perform inspec-
tion or maintenance.
• Never use gasoline, benzine, thinner, alcohol
or the like. Discoloration, deformation or cracks
may result.
OPTIONAL
ACCESSORIES
CAUTION:
• These accessories or attachments are recom-
mended for use with your Makita tool specified
in this manual. The use of any other accessories
or attachments might present a risk of injury to
persons. Only use accessory or attachment for
its stated purpose.
Abrasive belts
Clamp
NOTE:
• Some items in the list may be included in the
tool package as standard accessories. They
may differ from country to country.
MAKITA LIMITED WARRANTY